The care and maintenance of thermoplast machines is the key to ensuring the normal operation of equipment, extending the service life, improving the efficiency of production and the quality of products. Here are some basic care and maintenance measures:
Daily cleaning: regularly clean the injection molding machine inside and outside, keep the equipment clean and dry, especially remove garbage and residues such as plastic particles and waste inside to avoid damage to the equipment.
Lubrication: lubricate all parts of the pressurized injection machine regularly, use suitable lubricating oil and lubricating methods and avoid using too much or too little lubricating oil. Proper lubrication can ensure proper operation of the equipment and extend its life.
Maintenance of the plasticizing system: the plasticizing system is the main component of the injection molding machine and requires regular inspection and maintenance, including cleaning and replacement of sliding parts and seals, to maintain the stability of the equipment and the effectiveness of plasticizing.
Check the hydraulic system. The hydraulic thermoplastavtomat system requires regular inspection and maintenance, including inspection and replacement of hydraulic oil, as well as inspection of hydraulic components to prevent contamination and clogging of the valve core with particulate matter.
Electrical control system maintenance: check the tightening of the wiring connectors to avoid damage to the connectors affecting signal transmission. Clean the engine regularly, check the tightening of the heating cylinder and thermocouple, as well as the normal operation of the microcomputer control part. These measures help to preserve the cooling function of the electric cabinet and avoid the ignition of electrical equipment.
Maintenance in special circumstances: for example, in conditions of high temperature, special attention should be paid to the normal operation of the heat and cooling system of the injection machine, to check whether the oil temperature thermocouple is working normally, to ensure normal operation. Cooler and check if mechanical parts and rubber parts were deformed due to high temperature.
Maintenance before the stop: for example, before spring, it is necessary to carry out maintenance of the shape cavity, to clean the melt cylinder, to introduce new oil into the mobile guiding injection platform and the oil injection hole of the melt drive shaft, to protect the shape and machine and prevent corrosion and blockage.
