Saving Energy And Reducing Consumption Of Thermoplastavtomatoes

Energy saving of thermoplastavtomat can be divided into two parts: one - power part, the other - heating part.
Power saving: mainly frequency converters are used. The method of energy saving is to preserve the residual energy consumption of the engine. For example, the actual engine power is 50 hz, but in reality only 30 hz is required for production. Excessive energy consumption is wasted. The inverter modifies the output power of the engine to achieve energy saving.
Energy saving in the heating part: most of the energy saving in the heating part is achieved through the use of electromagnetic heaters. The energy saving level is about 30-70% of the energy saving level when using the old resistance coil.
1. Compared to resistive heating, electromagnetic heaters have an additional insulation layer, which increases the coefficient of thermal energy use.
2. In comparison with resistive heating, the electromagnetic heater directly affects the pipe with the material, heating it, reducing the heat loss in heat transfer.
3. Compared to resistive heating, the heating speed of the electromagnetic heater is more than a quarter higher, which reduces the heating time.
4. Compared to resistive heating, the heating speed of the electromagnetic heater is higher, which increases the efficiency of production and puts the engine into saturation, which reduces power losses caused by high power and low consumption.
The above-mentioned four points are the reasons why the feiru electromagnetic heater can save up to 30-70% of the energy on injection molding machines.