Injection blower is a device that combines injection and blowing functions and is commonly used in the manufacture of packaging materials such as plastic bottles. When using an injection blower, certain steps and precautions must be taken to ensure safe and efficient operation. General usage: 12
Before starting, make sure there are no obstacles around the device, the power cord is properly connected, and all the protective devices are in good condition.
Prepare materials: prepare empty bottles and raw materials according to production needs.
Set parameters: adjust filling time, interval time, manual/automatic transmission and other equipment parameters to meet production requirements.
Start of filling: place the pipe in the raw material barrel and start the filling equipment. Before formal filling, the space in the supply tube and pump shall be emptied to ensure the accuracy of filling.
Filling adjustment: if the amount of liquid being filled does not reach the expected level, you can adjust it accurately with the flow control handle below the pump.
Dryer and sealing: after filling, use the equipment blower function to dry the bottles with the dryer and seal the bottles with thermowelding or other means.
Cleaning and maintenance: after production, clean and maintain the equipment to ensure its smooth and safe operation next time.
When using the injection blower it is also necessary to pay attention to the following points:
Make sure that the equipment is used at the power voltage indicated on the passport plate and is properly grounded.
Keep the device's inlet and outlet free to avoid overheating or clogging.
When using the hair dryer function, observe a certain distance between the air outlet and the hair so as not to burn the hair.
After use, switch from the "hot" to the "cold" position and then switch off the power supply to use the remaining heat of the electric heating element.
